FAQs
General questions
Warning: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead in D:\Web\TEHO\wp-content\plugins\wordpress-faq-manager\faq-manager.php on line 637
Warning: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead in D:\Web\TEHO\wp-content\plugins\wordpress-faq-manager\faq-manager.php on line 638
How can I modify AT-PMSC-1 system to meet my special experimental requirements?
Due to modular design, some modifications are possible. Please contact us for further information.
Why is motor error message shown?
“Motor error!” message is shown when the ATM-C4G unit is not properly connected. Please make sure that the ATM-C4G power cable is connected, the unit is switched on and the emergency switch is released.
Why do I get switch error message on system startup?
Please make sure that ATS-500 switch is properly connected to the ATC-400 controller. When the system starts this is indicated by white LED on the switch front panel.
I keep pressing the red power button but nothing happens. What is wrong?
Please wait a few minutes for the system to boot. The button will change to yellow color during boot and to green when the controller is ready.
ATC-400 Operation
Warning: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead in D:\Web\TEHO\wp-content\plugins\wordpress-faq-manager\faq-manager.php on line 637
Warning: preg_replace(): The /e modifier is no longer supported, use preg_replace_callback instead in D:\Web\TEHO\wp-content\plugins\wordpress-faq-manager\faq-manager.php on line 638
How can I modify AT-PMSC-1 system to meet my special experimental requirements?
Due to modular design, some modifications are possible. Please contact us for further information.
Why is motor error message shown?
“Motor error!” message is shown when the ATM-C4G unit is not properly connected. Please make sure that the ATM-C4G power cable is connected, the unit is switched on and the emergency switch is released.
Why do I get switch error message on system startup?
Please make sure that ATS-500 switch is properly connected to the ATC-400 controller. When the system starts this is indicated by white LED on the switch front panel.
I keep pressing the red power button but nothing happens. What is wrong?
Please wait a few minutes for the system to boot. The button will change to yellow color during boot and to green when the controller is ready.